请问这是强制百兆全双工吗？怎么看是强制还是自适应，谢谢！
GigabitEthernet3/0/2currentstate:UPIPPacketFrameType:PKTFMT_ETHNT_2,HardwareAddress:0...
GigabitEthernet3/0/2 current state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0cda-418f-4200
Description: GigabitEthernet3/0/2 Interface
Loopback is not set
Media type is twisted pair, Port hardware type is 1000_BASE_T
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is not enabled
The Maximum Frame Length is 9216
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 801
Mdi type: auto
Link delay is 1(sec)
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 801
Port priority: 2 展开
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0cda-418f-4200
Description: GigabitEthernet3/0/2 Interface
Loopback is not set
Media type is twisted pair, Port hardware type is 1000_BASE_T
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is not enabled
The Maximum Frame Length is 9216
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 801
Mdi type: auto
Link delay is 1(sec)
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 801
Port priority: 2 展开
1个回答
展开全部
GigabitEthernet3/0/2 Interface
Loopback is not set
Loopback is not set
本回答被提问者采纳
已赞过
已踩过<
评论
收起
你对这个回答的评价是？
推荐律师服务：
若未解决您的问题，请您详细描述您的问题，通过百度律临进行免费专业咨询
