Question

电脑开机时出现The volume is dirty

Answer 1

电脑D盘有问题，老是蓝屏，再重启老是检测D盘，报：The Volume is dirty.

解决方法如下：

1）在"开始"-->"运行"下键入:cmd,进入msdos下，使用fsutil dirty query d: 来检查d盘，报：The Volume is dirty.再键入CHKNTFS /X D:，报该盘分区NTFS.

2）键入Chkdsk /f /r d:,会提示你：是否卸下所有的句柄，选Y，然后就分5个stage检测d盘（由于没了句柄，在check过程中D盘的东西不能用），结束后用 fsutil dirty query d:来测试发现结果：没有损坏。修复成功。

3)重新启动，发现系统好了。

将英文方案附在后面：

what you're experiencing is what Windows refers to as "setting the dirty bit" and what you have to do is unset that bit. Every time Windows XP starts, autochk.exe is called by the kernel to scan all volumes to check if the volume dirty bit is set. If the dirty bit is set, autochk performs an immediate chkdsk /f on that volume. Chkdsk /f verifies file system integrity and attempts to fix any problems with the volume. It is usually caused by a hard shut down or a power loss during a read-right operation on that particular drive.

How do I fix it, you ask?

Well, that's easy. First click Start> Run> bring up a command prompt by typing in "CMD" and type " fsutil dirty query d: ". This queries the drive, and more than likely it will tell you that it is dirty. Next, type "CHKNTFS /X D:". The X tells Windows to NOT check that particular drive on the next reboot. At this time, manually reboot your computer, it should not do a Chkdsk and take you directly to Windows.

Once Windows has fully loaded, bring up another CMD prompt and type and now you want to do a Chkdsk manually by typing "Chkdsk /f /r d:". This should take you through 5 stages of the scan and will unset that dirty bit. Finally, type "fsutil dirty query d:" and Windows will confirm that the dirty bit is not set on that drive.

Answer 2

系统垃圾文件过多，一般用360安全卫士和超级兔子之类的垃圾清理工具都能解决这个问题.

Answer 3

系统文件垃圾过多，建议用超级兔子之类的清理一下

Answer 4

这说明：
1.C盘文件系统是NTFS，但整个磁盘需要一致性检测，可以退出磁盘检查，但强烈建议继续。
在10秒钟内按任意键内跳过磁盘检查。

2.应该是文件系统有问题了，建议运行磁盘扫描扫描文件系统错误。

3.有可能是在Fat32转ntfs过程中转换不完全造成的错误。

最好的解决办法是备份文件，重新分区，这样可以从根本上解决问题。