Question

帮忙翻译一下，不要用翻译器

When the switch is positioned at
×1: Turning the wheel by one unit corresponds to the displacement of 0.0001 in.
×10: Turning the wheel by one unit corresponds to the displacement of 0.001 in.
×100: Turning the wheel by one unit corresponds to the displacement of 0.01 in.
7. JOG setting the selector switch in the JOG mode allows the selection of manual monotonous feeds along the x, y, and z axis.
8. CYCLE START Use this button during the execution of the program from MEMORY or TAPE. When the CYCLE START button is pressed, the control lamp located above this button goes on.
9. FEED HOLD when the FEED HOLD button is pressed, the control lamp located above the button goes on, and the control lamp located above the CYCLE START button goes off. When the FEED HOLD button is pressed, all feeds are interrupted; however, the rotations are not affected. (this button is used very rarely).
10. SINGLE BLOCK The execution of a single block of information is initiated by turning this switch ON. Each time the CYCLE START button is pressed, only one block of information will be executed.
11. DRY RUN DRY RUN is also used to check a new program on the machine without any work actually being performed by the tool.
12. REFERENCE RETURN turning this switch ON and then pressing buttons X, Y, or Z causes the machine to return to the zero position for each axis.

Answer 1

当开关定位于
× 1：将一个单位的车轮对应0.0001英寸位移
× 10：将一个单位的车轮对应0.001英寸位移
× 100：将一个单位的车轮对应0.01英寸位移
7。飞梭设置在飞梭模式选择开关允许人工选择沿单调的x，y供稿和z轴。
8。周期开始使用期间从内存或胶带程序执行这个按钮。周期开始时，按下按钮，控制灯高于此按钮，位于下去。
9。饲料的饲料所持HOLD按钮按下时，灯的控制按钮，位于上方的推移，上述控制灯的周期开始按钮，然后去了。当饲料HOLD按钮被按下时，所有资讯的中断，但是，旋转不会受到影响。 （这个按钮是用来很少）。
10。单块的单一信息块的执行发起，令这开关。每个周期开始时按下按钮时，只有一个信息块将被执行。
11。排练排练也可以用来检查，没有被实际的工具进行的任何工作在计算机上新项目。
12。引用返回打开此开关ON，然后按按钮的X，Y，或Z使机器返回到每个轴的零位。