Question

DSP2812仿真器与CCS3.3连接不上

有错误 d:\CCStudio_v3.3\cc\bin>xdsreset.exe -f ..\..\drivers\bhjtag3.cfg -p 0 -----[Select and reset the controller]--------------------------------------- This utility has selected an XDS510 class product. This utility will load the adapter 'bhjtag3.dll'. This utility will operate on port address '0x0'. An error occurred while soft opening the controller. -----[An error has occurred and this utility has aborted]-------------------- This error is generated by TI's USCIF driver. The value is `-202' (0xffffff36). The title is: `SC_ERR_CTL_TBC_ADDRESS'. The explanation is: A bad controller or support-logic address has been used. The selected port does not match the hardware configuration. The standard 560 ports are 0x0, 0x1, 0x2 and 0x3. The standard EVM ports are 0x0, 0x1, 0x2 and 0x3. The standard DSK ports are 0x378, 0x278 and 0x3BC. The standard 510 ports are 0x240, 0x280, 0x320 and 0x340. d:\CCStudio_v3.3\cc\bin>pause 请按任意键继续. . .

Answer 1

1看仿真器驱动是否安装成功
2看CCS驱动是否成功安装到安装目录
3配置正确
4连接即可
你的问题应该是驱动部分
看是不是和你仿真器配套，再者是不是CCS3.3的驱动。
如果你用的是实验箱，配套的可能是低级版本需要I/O端口的配置
CCS3.3一般不用。
只要按照实验说明去操作就行