Question

请帮忙翻译成英文

四、阴极电泳系统
本系统主要由阴极电泳主槽、副槽、循环搅拌系统、调漆系统、整流电源、备用电源、极液循环系统、冷水机组、冷却塔、电泳漆转移槽、漆液温控装置、超滤装置、纯水装置、排风系统及电控系统等组成。
1、电泳涂漆隧道
a、电泳涂漆线采用隧道式结构，电泳涂装线由电泳室及后冲洗段两部份组成。室体采用碳钢材料制成，后冲洗隧道采用不锈钢材料制成，焊缝采用连续焊封闭工艺，不容许有滴漏现象。在电泳槽两端设有检修平台。
b、各工位喷淋段两端设有挡水板，相邻工位之间设有滴水段，滴水段底部呈“山型”型，便于喷淋液自动回槽。
c、在电泳段及设有排风装置。
d、室体部位均采用连续焊密封，不容许有滴漏。
2、工艺槽
a、电泳槽采用主副槽结构，主槽出口端设有副槽，副槽体积为主槽体积的10%，槽体材料采用δ6碳钢钢板，槽内壁涂敷δ8-10mm玻璃钢防腐材料，能耐20000伏直流电压（任意一点不低于12000伏），电泳主循环泵用耐蚀泵，备用一台。电泳槽主副槽之间有连通管，电泳槽设温度控制系统，控温精度为±2℃。
b、电泳槽及后冲洗槽体的一端底部均设凹型沟，便于排污及清洗。
c、电泳主副槽底部均安装有循环搅拌管及文丘里喷头，提高电泳漆内循环能力，保证电泳槽每小时循环次数不小于4次，底部流速为0.4m/s，表面流速为0.2m/s。
d、电泳槽侧墙及底部有绝缘的固定阳极管和喷管的装置。
e、电泳槽有良好的接地。
f、所有后冲洗槽均是主副槽结构，都设有循环搅拌装置，后冲洗槽不容许泡沫外溢。
g、电泳槽两侧设有800mm宽的检修通道，照明充足。
3、喷淋装置
a、主要由喷淋泵、喷淋管、阀门、压力表、喷嘴等组成。
b、喷淋管路设计时考虑喷淋管上下排列的喷嘴压力均衡。
c、喷嘴采用聚丙烯快换万向球头喷嘴，UF水洗采用雾化喷嘴。
d、UF水洗工艺采用逆水洗法，相同槽液的水槽安装连通管，便于后道工序的槽液向前道工序溢流。
e、隧道顶部设悬链保护装置。
4、辅助设备
a、阳极系统
由阳极、阳极液储槽、泵及输液管路和仪表组成。阳极结构采用管式阳极，面积比为阳极：阴极=（6—4）：1。阳极系统装有流量计，阳极液通过泵循环，控制阳极液的电导率。当阳极液电导率起过工艺值时，纯水将自动打开纯水阀门，进入阳极液储槽。泵及阳极液储槽的材料采用SUS（或PVC）材质，输液管路采用选用SUS（或PVC），电极采用SUS。
b、超滤系统
由卷式超滤器、超滤器循环泵（采用耐蚀泵）备用1台泵、超滤液储槽、超滤液清洗槽及泵、超滤液输液泵、管路压力表、流量计、袋式过滤器等组成。超滤器透水能力1.0t/h（仅清洗时）。
c、加料系统
采用单组份搅拌系统。该系统由搅拌罐（不锈钢）、电机、摆线针轮减速器、搅拌泵、过滤器、输液泵等组成。

d、整流器
整流器输出电压为0-250V可调，输出电流为0-250A可调。
e、纯水系统
由反渗透管、泵、管路、原水储槽及泵、纯水储槽及泵、加药装置、压力表、电导仪等组成。供水能力1.5T/h（与前处理工序合用）。
f、水密封系统
水密封系统用于卧式泵的密封。水密封液为UF液，水封压力为0.35MPa。
g、冷冻系统
由冷冻机组、冷却塔、冷冻水泵及管路压力表、温度表、保温材料等组成。电泳涂漆过程中或漆液搅拌时会不断积累热量，所以需要在电泳漆循环系统中安装板式热交换器，由冷冻机产生的冷冻水供给热交换器，全自动降低漆的温度。冷冻机功率在10万大卡左右，为环保型冷冻机组。

Answer 1

4, cathode electrophoresis system
The system consists of electrophoretic main channel, the Deputy groove, loop mixing system, paint system, rectifier power supply, standby power, a very fluid circulation system, water chiller, cooling tower, electrophoresis paint transfer tank, paint liquid temperature control device, ultrafiltration equipment, water equipment, exhaust systems and electronic control systems and other components.
1, electrophoresis coating tunnel
a, electrophoresis coating line with the tunnel structure, electrophoresis coating line after the washing by the electrophoresis chamber and two-part segment. Chamber body is made of carbon steel materials, after the washing tunnel made of stainless steel, welding seam closed with a continuous process, does not allow drip phenomenon. With both ends of the electrophoresis tank maintenance platform.
b, section of the station ends with retaining plate spray, with water dripping between the adjacent station segment, the bottom paragraph was dripping "mountain-type" type, easy to automatically back to spray liquid tank.
c, in the electrophoresis section and with drainage devices.
d, E body parts are sealed by continuous welding, does not allow drip.
2, process tank
a, electrophoresis tank with main and groove structure, the main channel with Vice-slot outlet, the volume-based deputy slot 10% of tank volume, tank material used δ6 carbon steel plate, slot coating δ8-10mm glass wall steel anti-corrosion materials capability of 20,000 volts DC voltage (any point not less than 12,000 volts), the main circulating pump electrophoresis corrosion pump, spare one. Electrophoresis tank connected between the main and auxiliary tank pipe, electrophoresis tank based temperature control system, temperature control accuracy of ± 2 ℃.
b, electrophoresis tank and rinse tank after the end of the bottom of the concave groove located for easy discharge and cleaning.
c, electrophoresis tank at the bottom of all main and installation of cycle tubes and Venturi mixing nozzle, improve circulation within the ability of electrophoretic paint to ensure the electrophoresis tank cycles per hour, not less than four times the bottom of the flow rate of 0.4m / s, the surface flow rate of 0.2 m / s.
d, electrophoresis tank side wall and bottom of the fixed anode tube with insulation and nozzle devices.
e, electrophoresis tank with a good grounding.
f, after the rinse tank are all main and auxiliary tank structure, are equipped with loop mixing device does not allow the bubble after the rinse tank overflow.
g, electrophoresis tank with 800mm wide on both sides of the maintenance channel, sufficient lighting.
3 spray device
a, mainly by the spray pump, spray pipes, valves, pressure gauges, nozzles and other components.
b, spray pipe designed with spray nozzle arranged in the pressure tube from top to bottom balance.
c, nozzle with universal ball head quick change polypropylene nozzles, UF washing by atomizing nozzle.
d, UF washing process uses reverse washing method, the same as Bath sink installed connecting pipe, the following process to facilitate the bath overflow forward working procedure.
e, set up the tunnel at the top of hanging chain protection.
4, auxiliary equipment
a, anode system
From the anode, the anode liquid storage tanks, pumps and piping and instrumentation composed of infusion. Anode structure, a tubular anode area ratio of anode: cathode = (6-4): 1. Anode system with flow meter, the anode fluid through the pump cycle, control the electrical conductivity of the anode. Played when the anode process fluid conductivity value, the water will automatically open the water valve, liquid storage tank into the anode. Pump and liquid tank anode material using SUS (or PVC) material, infusion tube by use SUS (or PVC), electrode using SUS.
b, ultrafiltration system
Super filter by the volume, ultra filter circulation pump (pump with corrosion) reserve a pump, ultra-filtrate storage tank, tank and pump cleaning ultrafiltrate, ultrafiltrate infusion pumps, piping pressure gauge, flow meter, bag filter etc.. Ultrafilter permeable ability 1.0t / h (only cleaning).
c, feeding systems
Using one-component mixing system. The system consists of mixing tank (stainless steel), motor, cycloidal reducer, mixing pumps, filters, infusion pumps and other components.

d, rectifier
Rectifier output voltage is 0-250V adjustable, 0-250A output current is adjustable.
e, water system
By the reverse osmosis tube, pump, piping, raw water storage tank and pumps, water tanks and pumps, dosing devices, pressure gauges, conductivity meter etc.. Water supply capacity of 1.5T / h (with a combination of processes).
f, water sealing system
Water sealing system for sealing horizontal pumps. UF water seal fluid liquid, seal pressure 0.35MPa.
g, refrigeration system
By the refrigeration unit, cooling towers, chilled water pumps and piping pressure gauge, thermometer, insulation materials and other components. Electrophoresis lacquer paint mixing process or will continue to accumulate heat, so it is necessary to install the circulatory system in the electrophoretic paint plate heat exchanger, resulting from the freezer chilled water supply heat exchanger, automatic lowering the temperature of paint. Freezer power about 10 million kilocalories for environmentally friendly refrigeration units.

Answer 2

jealousy
can
make
a
bitch
our
of
a
woman.

呵呵，bitch用的太俗了，但是我挺喜欢这样的说法的

jealousy
can
make
a
woman
vicious.

Answer 3

绝对权威!!!!!!
In
our
daily
lives
every
family
will
have
a
lot
of
waste
electrical
and
garbage,
people
often
will
be
used
to
throw
away,
waste
electrical
appliances
and
garbage
in
a
lot
of
harmful
substances
pollute
the
environment
and
groundwater.
How
can
these
waste
electrical
and
garbage
reasonable
reuse,
so
that
they
become
available
renewable
energy?
So
that
they
do
not
play
their
waste
into
a
useful
value?
I
think
the
use
of
Waste
Electric
and
Xiandiling
bottles
and
eliminate
phone
charger,
invented
a
kind
of
highly
efficient
energy
saving
and
environmental
protection
[LED
Huwendeng],
thus
the
effective
use
of
electrical
appliances
and
garbage
waste
of
renewable
energy.
Removing
a
broken
light
bulbs
spiral
mouth,
out
of
the
waste
input
line
phone
charger
I
welding
lights,
installed
in
the
waste
Xiandiling
bottle
(Xiandiling
will
be
cut
from
the
bottle,
and
only
use
half
of
the
lights
in
the
mouth
wash
Nien
Ling
bottles
of
the
mouth
of
the
bottle)
then
a
combination
of
super-bright
light-emitting
diodes
used
in
the
welding-phone
charger
output,
fixed
Xiandiling
bottle
in
the
mouth
of
the
cut
end,
such
a
use
of
waste
materials
produced
highly
efficient
energy
saving
and
environmental
protection
[LED
Huwendeng
-
on
a
complete
system.