Question

DSP2812与XDS510仿真器连接不上，错误提示如下：

Error connecting to the target:
Error 0x80000200/-1031
Fatal Error during: OCS,
Device driver: Problem with the Emulation Controller.
It is recommended to RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.
Sequence ID: 0
Error Code: -1031
Error Class: 0x80000200
I/O Port = 240
Board Name: F2812 XDS510 Emulator
Cpu Name: CPU_1
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.

Answer 1

经常遇到这个问题，你把板子断电，仿真器拔了，再重插，上点，插的时候注意插紧，必要的时候那个microUSB口手按着，再重连，一般能好

Answer 2

你的板子和仿真器是偶尔连接不上还是一直就像这样没有链接上过？