Question

我的相机40D出出现ERR99问题,请问是什么原因.谁能帮帮忙告诉下`

.我刚百度了一下,貌似很多多原因.
我也镜头,卡,电池全都拆了再装`
卡也格式化了`
都没用`
送快修中心修的话得多长时间能修好`?
还有,收费是如何`?
谢谢`
是佳能40D`
头是副厂头,腾龙的28-75头`
还有，显示屏显示的是说重新开或者换块电池`
我有一块原装,一块副厂电池`
后面换了块副厂电池`
连开机都开不了了`

Answer 1

查了外国网站说了以下几种原因都会造成err99.
•Err99 results from an electronic communication problem between the lens and the camera.
因镜头和机身电路连接问题导致
•Err99 results from using third-party (i.e. Sigma, Tamron, Tokina) lenses.
使用第三方镜头导致
•Err99 means that electronic circuitry in the lens has failed.
镜头中电路错误导致
•Err99 means that electronic circuitry in the camera has failed.
相机中电路错误导致
•Err99 results from using third party batteries.
使用第三方电池导致
•Err99 is a firmware issue, and can be fixed by upgrading to the latest firmware.
固件问题导致，可以通过刷最新固件解决。
•Err99 started with Canon XT and 20D cameras.
err99问题起源于佳能 Rebel xt(国内即300d）和20d相机。
还有些其他原因如下:
•Using older battery (solved after replacing battery)使用了旧电池。
•Bad CF card (solved after replacing card)坏的cf卡。
•After marked temperature change (solved after letting the camera sit for a day or so, probably condensation)在温差较大的情况下使用。
•After mounting battery grip (solved after remounting the battery grip)在插入附加电池手柄后。
•With single lens only, all other lenses fine (solved by repairing the lens)单一镜头问题。更换镜头即解决。
•Early copies of 50D (solved after firmware update)早期50d固件。
•Camera used with third party shoe mounted flash (solved after flash removed)使用了第三方热靴闪光灯。
•Dirty contacts (solved by cleaning, sometimes that is the only problem)机身和镜头电子触点接触不良。
•For no apparent reason, it went away for good after doing the routine Err99 protocol. This part reminds me of “any sufficiently advanced technology is indistinguishable from magic”…对于无明确原因的问题，任何高科技都无法用魔力来解释清楚。
针对以上问题外国人提出了一下解决步骤：（当然并不一定奏效）
First, we pull a “tech support” reboot.（首先推荐一个“官方技术支持”式的重启）
1.Turn camera off.关机
2.Remove battery.取出电池
3.Replace battery.重装电池
4.Turn camera on.开机
5.Try a shot.试着拍摄。
Sometimes that works. If not then a full reboot:有时这样可以解决问题，若不行则来个完全重启。
1.Turn off the camera.关机
2.Remove the lens, battery, date-time battery (see below), and CF card.取下镜头、电池、日期电池和cf卡。
3.Allow the camera to sit without power for approximately 20 minutes with the power switch “on”. Recharge the battery during this time. (Full disclosure here: somebody once suggested the 20 minutes and power switch on part, we want to top off the battery anyway, and we’ve generally got other stuff to do so we do it this way. Waiting 30 seconds and using a different, fully charged battery would probably be just as good, but this is what we do.)在开关为“on”的状态下，放置20分钟。让其内部将余电消耗。这期间再给电池充电。
4.Turn off the camera, replace the backup battery, insert the fully charged battery, turn on the camera.关机，将充满电的备用电池插入，
开机。
5.Press the shutter button to check for Err99.按快门，检查err99.
6.If Err99 occurs, remove the battery, examine and clean the battery and camera connections. If at all possible, try a different battery.如果仍是err99。取出电池，检查并清洁电池和相机的触点，如果有可能，尽量换块不同的电池。
7.If Err99 still occurs, use the manual sensor cleaning function to raise the mirror and open the shutter. If the shutter does not completely open, it is the source of the problem. If a leaf is out of alignment, some people have reported using a soft brush to move the shutter leaf back into place. Personally, I’d send it in for service。若er99仍然出现，用手动清洁感光元件功能升起反光板，打开快门，若快门不能开启，则是快门的问题。如果快门叶片不在正确的位置，有人说用软刷子使其归位，但我个人认为这个不合适，还是交给客服更好。
8.If Err99 still occurs, the camera almost certainly needs service. You might try reinstalling firmware, but it’s unlikely to work.若err99仍然出现，那么这个机子真该去客服那儿了。你可以尝试重装固件，但不一定有效。
If there’s no Err99 after the above, the next step is to check the storage system:
如果以上操作完成后，err99消失，那么下面的步骤就是检查存储系统。
1.Insert and format CF card, then press the shutter button as you would to take a picture.插入并格式化cf卡。然后按下快门拍照。
2.If Err99 try a different brand and size of card. If no Err99, the problem was the card and you should be done.若出现err99，尝试换张别的牌子的或容量的卡。如果未出现err99，那就是卡的问题。
3.If Err99 still occurs with a different card, the problem is with the camera’s card connections, and repair will be necessary.如果换卡后err99仍然出现，那就是相机上与卡连接部位的问题。返修时必须的。
Finally, check the lens:最后检查镜头。
1.Turn the camera back off.关机
2.Gently clean the contacts on both the lens and the camera (see Note #2 below)
仔细清洁镜头与相机各自的触点。
3.Remount the problem lens, set to manual focus, IS off, widest aperture and take a picture.安装问题镜头，设为手动，关闭is防抖，最大化光圈。拍摄。
4.If no Err99 with everything off, activate autofocus, then IS, then stop the aperture down, taking a picture to confirm no ERR 99 after each step.在所有镜头功能关闭下，若无err99，则开启自动对焦，然后是is防抖，由此一步步找出问题。
5.If Err99 occurs, try a different lens. If only one lens is a problem, that lens needs servicing. You’ll get better service results when you can be specific: i.e. “Err99 only when IS activated, etc.” in your service request.如果还是有err99，试着换个镜头，若只是一个镜头的问题，那么那只头就该修了。尽量明确错误的具体地方，如，“只有当is开启时err99才出现。”
6.If Err99 occurs with more than one lens, and no other cause is apparent, the camera needs to head to Canon for repair.
如果多只镜头都有err99的问题，那么就送机身去维修站吧。

以上供参考。

Answer 2

听你描述，不确定是机身或是镜头的原因。
但你尽可能用原装附件和镜头，查看下是那里的问题，或是借一个镜头试试，多数情况下是快门组件故障。
我的40D也出现过ERR99，然后送到销售商那里，鉴定确实是机身问题。后来发到北京修理，是快门组件和主板出了问题，都免费更换了。因为我当时还在一年的质保期内。我记得那次送修用了2周时间。

Answer 3

我的40D报ERR99 换了几张卡都不好，拿到汉口上海路维修站去检测说是快门坏了，郁闷 ，我的快门还不到10W次啊，问下价格，真难接受，基本维修费都400多了，还不说快门多少钱了，还要到发到上海，关键是我要急着用啊，正在门口打电话想借个相机用，在门口看到对面有个相机，好像叫胜派相机维修，过去问了一下，350，全新原装现货，2个小时就解决，我擦，直接跑到佳能把相机拿出来，给他吼去， 不修了，让胜派2个小时给解决了，老板说，换的快门给你保10W次，或者3个月，你选，我自己玩又不是开影楼，选10W次。佳能买新机都没给你保10W次的，还号称10W次快门，你敢给保10W次么？

Answer 4

佳能绝技，用副厂（哪怕只是电池）就给你出err99。。。佳能一向是让人感动常在的，送修吧

Answer 5

送维修吧。我有经验