Question

我新安装了proe5.0 M060的版本，无法破解

我新安装了proe5.0 M060的版本，在运行MAGNiTUDE破解文件里面的PTC_WF5_Corrector.exe后，怎么运行不了，无法破解，请告诉帮帮忙！！！
我这个破解文件“MAGNiTUDE”中有这些文件：PTC_WF5_Corrector.exe，ptc.exe， ptc.dat，keygen.bat，没有你说的那些文件。

Answer 1

PTC_WF5_Corrector.exe 文件应该放在proe5.0的前一个目录下
一般都是program files文件下运行，弹出一个批处理对话框，等一会就好了。
如果还是不能用，干干净净的卸载掉重新再破解。
我用proe5.0 m060快半年了。

Answer 2

已发
注意查收哦

Answer 3

1) Start pro/e setup

2) Open license.dat with any txt-editor and replace every occurance of 00-00-00-00-00-00 with your computer real HOST_D (same one shown in the bottom left corner of the Pro/e setup). Save the license.dat

3) Install proe - proe_mech -ptc_distributed_services (optional). On license-config screen select "nodelocked license" and point to edited license.dat

Next apply a patches (if u didn't install the complete package, you will get "File not found" errors, accept or bleed)

for pro/engineer:
Copy "proe_WF5_Win64_crk.exe" to folder <proeWildfire 5.0 progdir>\i486_nt\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"

for pro/mechanica
Copy "proe_mech_WF5_Win64_#1_crk.exe" to folder <proeWildfire 5.0 progdir>\i486_nt\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
Copy "proe_mech_WF5_Win64_#2_crk.exe" to folder <proe mech WF5 progdir>\i486_nt\ptc and click "Start > OK"

for ptc distributed services
Copy "ptc_distributed_services_WF5_Win64_crk.exe" to folder <ptc_distributed_services WF5 Win64 progdir>\i486_nt\obj and click "Next > OK > Finish > OK"

That's all.. Enjoy :) 这样安装是可以使用的 我自己的就是这样安装使用的