Question

十万火急啊！！哪位大哥大姐帮忙翻译一下啊！！！

KO Pins usually extend to the surface lying parallel to the mold face. IF KO pins push on anagle surface, consider adding the grooves to the part design to prevent the deflection. KO pins extending to narrow walls and edges can be stepped or positioned, so that only a portion of the pin contactsd the molded part. This avoid using small-dimeter KO pins that are more difficult to maintain and can deflect or bend. KO pins leave witness marks, small indetations or ring where the pin contacts the part, that coul be objectionable on cosmtic surface. Addtionally, they can rad-through to the opposite surface if the part is difficult to eject, or if the ejector area is too small. Many factors determine the amount of ejector areas needed, including the part geometry, mold finish, material-release characteristics, and part temperature at the time of ejection. To prevent damage during ejection, thin-walled parts generally require large ejector and greater ejector area than comparable parts with thicker walls
Drawing Polishing the mold steel in the direction of ejection gnerally helps ejection. Thermoplastics polyurethanes, exception to this rule, usually eject more easily from molds with frosted finishes that limit plastic-to-metal contact the peaks in the mold texture. Core shift and mold flexture can pinch part surfaces, hindering ejection. Top prevent this problem, add support to mold and core, or change the filling pattern to balance the injection forces.

Answer 1

翻译软件里的 不好表怪我
通常击倒大头针对对模子脸的表面说谎平行扩充。 如果击倒大头针急忙前进 anagle 表面, 考虑把凹槽加入部份设计避免歪斜。 扩充变窄墙壁而且锐利的击倒大头针能被踏或放置, 所以只有大头针 contactsd 的部分被形成的部份。 这避免使用更困难维持的小-二韵脚击倒大头针而且能使或者偏斜弯曲。 击倒大头针离开证人标志，小的 indetations 或者大头针连络部份， coul 在 cosmtic 表面上是该反对的戒指。 Addtionally, 他们能 rad-穿越对相反的表面，如果部份难以逐放, 或如果驱逐者区域太小。许多因素决定 , 被需要的驱逐者区域的数量,包括部份几何学, 形成完成，材料-释放特性, 而且在喷出的时候分开温度。为了要在喷出期间避免损害, 使-变薄通常墙壁部份超过和较厚的墙壁的可比较的部份需要大的驱逐者和较大的驱逐者区域
喷出 gnerally 的方向的图画抛光模子钢帮助喷出。热后可塑性物质聚亚安酯 , 这一条规则的例外,通常从和限制塑料的复着霜的完成模子更容易逐放-到-模子质地的金属连络峰巅。 核心变化和模子 flexture 能掐部份表面,阻碍喷出。 顶端避免这一个问题, 增加支持形成和核心, 或改变充填物式样平衡 injec