Question

cisco2621xm路由器设置问题，设置完了不能上网，高手赐教

我现在的应用是用2621XM做网着上网，2621XM两个百兆以太口，0/1连外网、0/0连内网，外网通过光纤接到联通，IOS是c2621xm-ix-mz.122-8.T5.bin。现在什么都设置好了，可就是上不了网（在路由器里可以ping通联通网关，不可以ping通其它IP，在下边的电脑上上不了网。光纤和公网IP都没问题我试过）。下面是我的具体配置信息，大家给看看是那的问题
Building configuration...
Current configuration : 563 bytes
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router
!
!
ip subnet-zero
!
interface FastEthernet0/0
ip address 192.168.125.253 255.255.255.0
duplex auto
speed auto
!
interface FastEthernet0/1
ip address 60.29.XX.XX255.255.255.248
duplex auto
speed auto
!
ip classless
ip route 0.0.0.0 0.0.0.0 FastEthernet0/1
no ip http server
ip pim bidir-enable
dial-peer cor custom
!
gatekeeper
shutdown
!
!
line con 0
line aux 0
line vty 0 4
login
!
!
end
0/1信息
Router#sh int fastEthernet 0/1
FastEthernet0/1 is up, line protocol is up
Hardware is AmdFE, address is 000e.8457.4341 (bia 000e.8457.4341)
Internet address is 60.29.XX.XX/29
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:14, output 00:00:07, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
313 packets input, 18890 bytes
Received 277 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
661 packets output, 52131 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Router#
版本信息
ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)
Router uptime is 41 minutes
System returned to ROM by reload
System image file is "flash:c2621xm-ix-mz.122-8.T5.bin"

Answer 1

你没做nat转换啊，内网肯定上不了；加上以下命令
Router(config)#access-list 101 permit ip any any
Router(config)#ip nat inside source list 101 interface FastEthernet0/1 overload
Router(config)#interface FastEthernet0/1
Router(config-if)#ip nat outside
Router(config)#interface FastEthernet0/0
Router(config-if)#ip nat inside
你那个默认路由最好的话改成网通的网关地址，

Answer 2

其他客户端的IP是什么样的? 如何获得IP的?网关是哪个?