Question

求翻译,谢谢!

1.合金材应经热处理后软态交货，据供需双方协议，可供其他状态的合金材。
2.直径为0.50～6.00mm的丝材，在规定的芯棒上缠绕5圈后，表面不得出现分层及裂纹。铁铬铝丝材允许用反复弯曲试验代替缠绕试验，反复弯曲次数不得小于5次。
3.厚度大于0.80mm冷轧带材应做弯曲试验，其弯曲处不得出现分层及裂纹。
每轴(盘)丝材任意部位每米电阻均匀性不得超过4%，每卷冷轧带材任意部位每米电阻均匀性不得超过5%。

Answer 1

1. Alloy Material should be after heat treatment delivery soft state, according to supply and demand in the agreement, the other for the state of alloy materials.
2. The diameter of 0.50 to 6.00mm silk material, the provisions of the mandrel wound after five laps, the surface may not have a layered and crack. Aluminum chromium iron wood allows repeated bending test pilot instead of winding, repeatedly bending frequency of not less than five times.
3. The thickness greater than 0.80mm cold rolling strip bending test should be done, there should not bend and crack stratification.