Question

麻烦各位大侠帮忙翻译下，急！！！万分感谢！！！

1、 用无尘布将刮片一侧包整齐，然后用刮片的侧面将待贴膜产品表面要贴膜的位置刮干净（刮时要认真检查）。
2、将保护膜的②面朝下放置于贴膜器的表面，从贴膜器的背面用吸球通过三个通孔中间位置吸住保护膜，然后将带有吸球的保护膜取下。
3、将保护膜①面的离型膜撕掉，将带有吸球的保护膜通过通孔放置于贴膜器正面，然后拖动吸球手柄直至保护膜的整个面通过水吸附在贴膜器上，当水扩散至整个面的80%以上即可。确定保护膜完全吸附在贴膜器上后，将吸球从保护膜上取下。

Answer 1

Use clean wiper blade neat package will be on one side, then use the side of the blade will stay paster product surface to patch position scraper (shave should seriously check).

Will film (2) face down on the surface of the skin, the skin from the back of the suction with a ball through the hole three middle position absorb protective film, then will suck the protective film on the ball with them.

Will the protective film (1) from type membrane tear, will suck the ball with the protective film on the hole through the skin in place to positive, and then drag the ball until the suction protective film the whole face through the water adsorption in the skin, when the water over to the entire surface can be more than 80%. Determine the protective film on the skin completely adsorption, will suck the ball from protective film take.