Question

急急急！！！！！！！！！！那位能帮我翻译一下，（要用专业英语）！！！！不胜感激！！！

内容简介

该模具是生产30%增强尼龙翻转盒的。是一副比较典型的塑料模具，它不仅包括有镶拼的型腔、侧向抽芯结构、动定模都有成型的型芯，还有延时抽芯机构。它独特性就在于侧向锁紧楔这里，一般的滑块锁紧装置都不需要辅助锁紧系统，而这副模具就有是为了成型后面的凸起部分。如果没有的话，由于模具型腔的压力给予侧向的力过大，导致侧凸部分就会成型失败。延时抽芯时为了在开模时，等锁紧楔垂直部分离开了滑块才进行开模，不让由于锁紧楔阻挡滑块这个侧面不能开模。该模具生产的制件是长壁制件，脱模后贴在型芯上，推出机构用的是靠近制件壁穿型芯的推杆。

Answer 1

Brief Introduction

The die is the production of nylon turnover increased 30 per cent of the box. Is a typical plastic mold, which not only include Xiangpin the cavity, lateral core pulling structure, the dynamic model has forming the core, delay core pulling bodies. Its uniqueness lies in lateral locking wedge here, the general slider locking devices do not require auxiliary locking system, and this pair is to die alone behind the arch forming part. If not, due to the mold cavity pressure to the side of too much, resulting in scoliosis will be forming part of the failure. To delay at the core pulling in a mode, such as locking wedge from the vertical part of a slider to open mode, so as locking wedge block slider this side could not die. The mold of the parts is parts of the wall, after Stripping posted on the core, the agency launched using a wall around parts wear core putt.

Answer 2

。。。给你一个翻译的网址。这样你以后就方便多了。

http://fanyi.cn.yahoo.com/

。。。希望可以帮到你～