Question

求助 思科cisco 无线AP 无线接口无限重启

本人小白 尝试配置cisco无线AP，设定好IP和网关SSID（广播选项已经勾上）等以后，尝试开启Radio0-802.11n 2G.Hz（我使用的是这个频段），在web管理界面看到Software Status 和Hardware Status分别是Disabled和Down，然后在超级终端中看到以下代码：
*Mar 1 00:09:14.010: soap_pci_reconfig_radio: radio id 0
*Mar 1 00:09:15.342: %SYS-5-CONFIG_I: Configured from http by on 192.168.0.15
*Mar 1 00:09:28.202: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Mar 1 00:09:28.210: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Mar 1 00:09:28.218: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to resetPCI reset port 0
*Mar 1 00:09:29.526: soap_pci_reconfig_radio: radio id 0
*Mar 1 00:09:43.710: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Mar 1 00:09:43.718: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Mar 1 00:09:43.726: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to resetPCI reset port 0
*Mar 1 00:09:45.034: soap_pci_reconfig_radio: radio id 0
*Mar 1 00:09:59.221: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Mar 1 00:09:59.229: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Mar 1 00:09:59.237: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to resetPCI reset port 0

求各位大神帮助

Answer 1

你好，请问你最后是怎么处理的？

Answer 2

radio 报错， 你还是升级IOS先，升级一下看下能否解决问题

Answer 3

是fit还是FAT模式，前者的话看下端口也没有加入到模板里面

Answer 4

这个比较奇怪，建议将设备恢复出厂再配置一遍。
另外，可以厂商再开一个SSID，看是不是还是这个问题，感觉不太正常

追问

恢复重做了N遍 最后跟上海同事交流 这个问题这个AP在上海的时候就存在，打算重新刷一遍ios然后再试试。。如果实在不行就只能退货了

追答

恩恩，不行的话就找厂商做一下升级固件吧，估计软件有问题了，再不行只能换货或者退货了