Question

h3c wa1208e-g 如何配置

* H3C WA1208E BOOTROM, Version 1.12 *
* *
******************************************************************

******************************************************************
* *
* H3C WA1208E BOOTROM, Version 1.12 *
*
******************************************************************

SDRAM Periphery Interlinkage Test...........................................OK
SDRAM Internal Unit Test....................................................OK
BOOTROM Checksum Verify.....................................................OK
Lanswitch chip self test....................................................OK

Finished initializing app file info area successfully!

Copyright(c) 2004-2007 Hangzhou H3C Technologies Co., Ltd.
CPU type : Intel IXP422 - IXDP422 BE
Memory Size : 64MB

Press Ctrl-B to enter Boot Menu... 4
0
Auto-booting...

Decompress Image.......................................................done!

Auto boot app file is WA1208E-CMW310-R1103L02.app!

Starting at 0x100000...

The boot app file WA1208E-CMW310-R1103L02.app is good!

NOTICE: Last reset info is corrupted!
Value from device is:08ac,08acDriver Dma at:0x3dc88b4!

WMAC low level init Success!

PerformanceBase : 0x10011
Set AUX device link OK!!

ETH MAC INITIALIZATION OK.
ETH PHY INITIALIZATION OK.

Line Aux0 is available
WMAC High level init finish!

Press ENTER to get started.
ETH UP!
上面的是我的H3C显示的内容，不知道怎样进入

Answer 1

# 创建无线接口

[AP]interface WLAN-BSS2

# 配置无线服务模板

[AP]wlan service-template 2 crypto

[AP-wlan-st-2]ssid h3c-wep

[AP-wlan-st-2]authentication-method open-system

[AP-wlan-st-2] cipher-suite wep40

[AP-wlan-st-2] wep default-key 1 wep40 pass-phrase 12345

[AP-wlan-st-2]service-template enable

# 在射频口绑定无线服务模板和无线口

[AP]interface WLAN-Radio 1/0/2

[AP-WLAN-Radio1/0/2]service-template 2 interface WLAN-BSS 2

# 配置VLAN虚接口

[AP]interface Vlan-interface1

[AP-Vlan-interface1]ip address 192.168.1.50 255.255.255.0

# 配置缺省路由

[AP-Vlan-interface1]ip route-static 0.0.0.0 0.0.0.0 192.168.1.1

具体可以看操作手册