MPLAB X IDE v1.95用ICD3编程器烧写出错的解决方法
ConnectingtoMPLABICD3...FirmwareSuiteVersion.....01.29.33Firmwaretype..............PI...
Connecting to MPLAB ICD 3...
Firmware Suite Version.....01.29.33
Firmware type..............PIC18FJ
Target detected
Target Device ID (0x0) does not match expected Device ID (0x1fa0).(红字)
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x13eff
configuration memory
Programming...
program memory
Address: 0 Expected Value: e3 Received Value: 0
Failed to program device (红字) 展开
Firmware Suite Version.....01.29.33
Firmware type..............PIC18FJ
Target detected
Target Device ID (0x0) does not match expected Device ID (0x1fa0).(红字)
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x13eff
configuration memory
Programming...
program memory
Address: 0 Expected Value: e3 Received Value: 0
Failed to program device (红字) 展开
展开全部
此问题说明ICD3与编程器软件配置的不符造成。
解决方法按图进行即可:
追问
方法非常管用！
本回答由提问者推荐
已赞过
已踩过<
评论
收起
你对这个回答的评价是？
推荐律师服务：
若未解决您的问题，请您详细描述您的问题，通过百度律临进行免费专业咨询
