请高手帮我翻译不要用翻译软件的谢谢!
烧结工艺由五大系统构成,分别是:配料系统,混合系统,烧结系统,冷却系统和筛分系统。首先从配料系统开始谈起,配料主要由铁矿粉,燃料,熔剂,返矿构成。1铁矿粉的指标是含铁品味...
烧结工艺由五大系统构成,分别是:配料系统,混合系统,烧结系统,冷却系统和筛分系统。
首先从配料系统开始谈起,配料主要由铁矿粉,燃料,熔剂,返矿构成。
1铁矿粉的指标是含铁品味高 成分稳定 杂质少,力度小于5mm的矿粉
2 熔剂由生石灰(CAO)和白云石组成
对生石灰的指标要求是含水3%左右 90%粒度在3mm
3 燃料主要为焦粉和无烟煤
对燃料的要求是碳含量高 成分稳定 灰分低 挥发分低 含硫低 含水小于10% ,95%粒度 小于3mm
4返矿
这些配料分别装入料罐中通过运输带运送到混合系统中通过混合机对烧结料进行混合
混合目的:使烧结料的成分均匀,水分合适,易于造球,从而获得粒度组成良好的烧结混合料,以保证烧结矿的质量和提高产量。我们一般采用二次混合技术 一次混合的目的:润湿与混匀,。二次混合的目的:继续混匀,造球,以改善烧结料层透气性和湿度
然后进入烧结系统
先铺一层粒度为10~25mm,厚度为20~25mm的小块烧结矿作为铺底料,其目的是保护台车底部粘料和烧损
铺完底料后,随之进行布料。布料时要求混合料的粒度和化学成分等沿台车纵横方向均匀分布,并且有一定的松散性,表面平整。
然后用点火器点火对烧结料进行燃烧同时抽风机在台车底部工作此时应注意台车的速度和烧结层垂直速度。然后将烧结好的烧结矿进行破碎,破碎后的烧结矿进入冷却系统,冷却后进入筛分系统,筛分机上的烧结矿运往高炉使用,筛分机下矿的作为返矿使用。 展开
首先从配料系统开始谈起,配料主要由铁矿粉,燃料,熔剂,返矿构成。
1铁矿粉的指标是含铁品味高 成分稳定 杂质少,力度小于5mm的矿粉
2 熔剂由生石灰(CAO)和白云石组成
对生石灰的指标要求是含水3%左右 90%粒度在3mm
3 燃料主要为焦粉和无烟煤
对燃料的要求是碳含量高 成分稳定 灰分低 挥发分低 含硫低 含水小于10% ,95%粒度 小于3mm
4返矿
这些配料分别装入料罐中通过运输带运送到混合系统中通过混合机对烧结料进行混合
混合目的:使烧结料的成分均匀,水分合适,易于造球,从而获得粒度组成良好的烧结混合料,以保证烧结矿的质量和提高产量。我们一般采用二次混合技术 一次混合的目的:润湿与混匀,。二次混合的目的:继续混匀,造球,以改善烧结料层透气性和湿度
然后进入烧结系统
先铺一层粒度为10~25mm,厚度为20~25mm的小块烧结矿作为铺底料,其目的是保护台车底部粘料和烧损
铺完底料后,随之进行布料。布料时要求混合料的粒度和化学成分等沿台车纵横方向均匀分布,并且有一定的松散性,表面平整。
然后用点火器点火对烧结料进行燃烧同时抽风机在台车底部工作此时应注意台车的速度和烧结层垂直速度。然后将烧结好的烧结矿进行破碎,破碎后的烧结矿进入冷却系统,冷却后进入筛分系统,筛分机上的烧结矿运往高炉使用,筛分机下矿的作为返矿使用。 展开
3个回答
展开全部
The sintering process is composed of five systems constitute, respectively is:batching system, hybrid system, the sintering system, cooling system andscreening system.
From the first batch system began to speak of, raw materials mainly composed of iron ore powder, flux, fuel, mineral composition.
1 iron ore index is the iron containing high taste components stability fewer impurities, mineral powder strength less than 5mm
2 flux by lime (CAO) and dolomite
Requirements for the lime water index is about 3% 3mm in size 90%
3 main coke and anthracite as fuel
The fuel requirement is high carbon content of ash composition and stability of low volatile low sulfur and low moisture content less than 10%, 95% the size of less than 3mm
4 mine
These ingredients are loaded into the material tank by mixing machinetransported to sintering material is mixed with the transport system
Objective: the mixed sintering of uniform composition, proper moisture, easyballing, so as to obtain the size composition of sinter mix well, to ensure the quality of sintered ore and increase the yield of. We generally use two time mixing technology a hybrid objective: wetting and blending,. Two hybrid objective: tomixing, pelletizing, in order to improve the air permeability of sinter and humidity
Then enter the sintering system
The first layer of the particle size is 10 ~ 25mm, thickness 20 ~ small sinter 25mmas bedding material, its purpose is to protect the trolley bottom material stickingand burning
Spread the bottom material, then the cloth. Cloth mixture particle size and chemical composition of uniform distribution along the trolley vertically and horizontally, and a loose, smooth surface.
Then use the igniter combustion and exhaust fan at the bottom part of the trolleywork at this time should pay attention to the trolley speed and sintering layer vertical velocity on the sintered material. Sinter and then sintering fine crushing,sinter crushed into the cooling system, the cooling system into the screen, screensinter extension to the blast furnace, screen mine mine used as.
求采纳,纯手动
From the first batch system began to speak of, raw materials mainly composed of iron ore powder, flux, fuel, mineral composition.
1 iron ore index is the iron containing high taste components stability fewer impurities, mineral powder strength less than 5mm
2 flux by lime (CAO) and dolomite
Requirements for the lime water index is about 3% 3mm in size 90%
3 main coke and anthracite as fuel
The fuel requirement is high carbon content of ash composition and stability of low volatile low sulfur and low moisture content less than 10%, 95% the size of less than 3mm
4 mine
These ingredients are loaded into the material tank by mixing machinetransported to sintering material is mixed with the transport system
Objective: the mixed sintering of uniform composition, proper moisture, easyballing, so as to obtain the size composition of sinter mix well, to ensure the quality of sintered ore and increase the yield of. We generally use two time mixing technology a hybrid objective: wetting and blending,. Two hybrid objective: tomixing, pelletizing, in order to improve the air permeability of sinter and humidity
Then enter the sintering system
The first layer of the particle size is 10 ~ 25mm, thickness 20 ~ small sinter 25mmas bedding material, its purpose is to protect the trolley bottom material stickingand burning
Spread the bottom material, then the cloth. Cloth mixture particle size and chemical composition of uniform distribution along the trolley vertically and horizontally, and a loose, smooth surface.
Then use the igniter combustion and exhaust fan at the bottom part of the trolleywork at this time should pay attention to the trolley speed and sintering layer vertical velocity on the sintered material. Sinter and then sintering fine crushing,sinter crushed into the cooling system, the cooling system into the screen, screensinter extension to the blast furnace, screen mine mine used as.
求采纳,纯手动
语言桥
2024-02-28 广告
2024-02-28 广告
寻找翻译公司可以通过多种途径。首先,可以在搜索引擎中输入“翻译公司”或者“翻译服务供应商”,然后筛选出符合自己需求的翻译公司。此外,也可以通过行业协会、专业论坛等途径找到可靠的翻译公司。在选择翻译公司时,需要考虑其资质、专业领域、翻译质量、...
点击进入详情页
本回答由语言桥提供
展开全部
众所周知,巨大的资金投入是电子商务健康发展的基本条件。中国的电子商务一直发展缓慢,缺乏资金投入正是其根本原因。纯手工翻译。
已赞过
已踩过<
评论
收起
你对这个回答的评价是?
展开全部
众所周知大量的资金投入是电子商务健康稳定发展的一个基本条件。中国的电子商务正在经历一个缺少资金投入的阶段,这就是中国电子商务之所以发展缓慢的一个基本原因。
已赞过
已踩过<
评论
收起
你对这个回答的评价是?
推荐律师服务:
若未解决您的问题,请您详细描述您的问题,通过百度律临进行免费专业咨询