Question

求以下英语人工翻译，万分感谢！

1、改模加长胶门体弹簧扣位筋尺寸, 因17系列平台的胶门体结构是一致的;目前开发已对17平台的扣位原有的基础上增加1MM并在扣位边沿加料起筋.现扣位厚料已达到2.5MM从而来增加扣位的强度达到标准要求；

2、将吸收微波的负载（比如砖或室温水做负载）放置在炉腔内，按正常使用情况将门打开或关闭，门应从关闭的位置打开到135°～180°之间,如炉门可打开的最大位置小于135°,则应将门打开至最大的开启位置上,操作的速率为每分钟六个周期，共连续操作10000个周期。在试验过程中或试验结束后，观察铁门体、门钩等是否正常使用，测试结果为合格（具体见胶门体门钩挂弹簧处改模后测试验证报告）

Answer 1

1, change extended plastic door module position buckle spring bars size 17 series platform for the plastic door structure is the same; the current development has been withheld for 17-bit platform to increase based on the original edge of 1MM and feeding in the buckle position from the tendon. now button bit had reached 2.5MM thick material to increase the deduction to the strength of digital standards;

2, the absorption of microwave load (such as brick or room temperature water on the load) placed in the oven cavity, the normal use of door to be opened or closed, the door should be open to the closed position 135 ° ~ 180 ° between, such as the door to less than the maximum open position of 135 °, it should open the door to the largest open position, the operation rate of six cycles per minute, a total of 10,000 cycles continuous operation. During the test or tests after the observation of iron body, such as whether the normal use of the door hook, the test results in compliance (see, plastic door hook door to change the spring after model testing and validation Office Report)